19
BAUMATIC BDW13, BDW14 dishwasher user manual
BEFORE YOU CALL FOR SERVICE ...
CHECKING AGAINST THE CHARTS BELOW MAY FIX YOUR PROBLEM.
PROBLEM
Dishwasher
doesn't run!
Drain Pump
doesn't stop!
POSSIBLE CAUSES
Fuse blown, or the
•
circuit breaker acted
Power supply is not
•
turned on
Water pressure is low
•
... And (situation A)
•
the number 17 is
showing on the
display. This means
that your dishwasher
has entered Test
Mode – a factory
sequence which you
need not concern
yourself with. This
happens because the
Delay Timer key was
pressed before the
'ON/OFF' key was
pressed.
... Or (situation B)
•
the display shows one
of the following: 0A,
09, 08, 07, 06, 05,
04, 03, 02, 01, 00.
Overflow
•
19
WHAT TO DO
Replace fuse or reset circuit
•
breaker.
Remove any other appliances
•
feeding from the same socket as
the dishwasher.
Make sure the dishwasher is turned
•
on and the door is closed securely.
Check that the water supply is
•
connected properly and the water is
turned on.
For situation A, Press and hold
•
down the Delay Timer key at the
same time as you're pressing the
'ON/OFF' button to switch the
dishwasher off.
Wait a few
seconds then press only the
'ON/OFF' button again. You are
now ready to program your
dishwasher for a washing cycle as
per usual.
For situation B, Press 'ON / OFF'
•
button to turn the dishwasher off.
Then, press and hold down the
Program Key ('P') at the same
time as you're pressing the 'ON /
OFF' button to switch the
dishwasher on again. You are now
ready to program a cycle as per
usual.
The system is designed to detect an
•
overflow. When it does, it shuts off
the circulation pump and turns on
the drain pump. Call a Baumatic
Ltd approved technician.