GE LOGIQ E9 Service Manual page 89

GE
D 5573152-100, R
IRECTION
Section 3-8
Connectivity overview
NOTE: If you are new or unfamiliar to connectivity on the LOGIQ E9, read Chapter 16, Customizing
Your System, of the Basic User Manual before you continue with the next descriptions and
procedures.
3-8-1 Physical connection
3-8-1-1 Stand-alone LOGIQ E9
No network connection needed.
3-8-1-2 Sneaker Net environment
No network connection needed.
3-8-1-3 Wired Ethernet from LOGIQ E9 to a Workstation
3-8-1-3-1 Direct Cable Connection from the LOGIQ E9 to a Workstation via a Crossover Cable.
You will only need a Crossover Cable for network use to connect the two units this way.
1.) Connect one end of the crossed network cable to the network connector on the LOGIQ E9.
2.) Connect the other end to the network connector to the Workstation, see the Workstation Service
Manual.
3-8-1-3-2 Connection via a Peer-to-Peer Network
You will need a network switch and one network cable for each unit connected to the switch.
3-8-1-3-3 Connection via Hospital Network
You will need one network cable to connect the LOGIQ E9 to a wall outlet on the hospital's network.
3-8-1-4 Connection using Wireless Option (R2.x.x or later)
Refer to:
-
-
Section 3-9
Connectivity Setup and Tips
Refer to the LOGIQ E9 Basic User Manual.
. 2
EV
Chapter 5 for theory.
Chapter 16, Configuring Connectivity of the LOGIQ E9 Basic User Manual.
Chapter 3 LOGIQ E9 Setup
LOGIQ E9 S M
ERVICE ANUAL
3 - 35