GE LOGIQ E9 Service Manual page 486

GE
D 5573152-100, R
IRECTION
8-8-2-4 Rear Casters removal
1.) Turn Front Casters so they are pointing forwards.
2.) Activate Direction Lock.
3.) Put the Bevel Edged Board on the floor.
WARNING WARNING Prior to elevating scanner, verify that the floating Operator Panel is locked in its lowest,
parking position.
Use extreme caution as long as LOGIQ E9 is un-stable, not resting on all four Casters.
WARNING WARNING
4.) Pull the system backwards up the board incline. This will lift the Rear Wheel on the opposite side of
the System from the floor.
5.) Turn the Rear Caster that stands on the Bevel Edged Board in the direction as shown in
Figure
6.) Activate the brakes.
7.) The system is now nearly balanced between one Front and one Rear Caster.
8.) Make the LOGIQ E9 rest on both Front Casters and lift the Rear Caster. Put the Wooden Wedge
under the chassis. This will stabilize the LOGIQ E9 with one Rear Caster free from the floor. This
Rear Caster can now be removed.
9.) Unscrew and remove the fixing bolt. Save the bolt for later use.
10.)Remove the Rear Caster.
8 - 202
. 2
EV
8-55.
Figure 8-55 Pull system backwards up the board incline
Section 8-8 - Casters and Brakes replacement
LOGIQ E9 S M
ERVICE ANUAL