Table of Contents
Advertisement
o
Enclosure w/o dome: 138*163*250mm / 5.5*6.4*9.85 inch
Enclosure with domes: 190*209*250mm / 7.5*8.2*1.6 inch
o
•
Weight without camera and batteries: 2.2 kg/4.8 lbs.
•
Weight with camera and batteries: 3.7 kg/8.2 lbs.
•
Battery life, controller: up to 12 hours
PREPARATION BEFORE CLOSING THE ENCLOSURE
• Ensure the DHCP setting of the Insta360 Pro/Pro2 is set to "Direct" and fan is
set to "On".
• Insert the camera into enclosure and ensure the lens is centered.
• Connect the Ethernet cable to the camera.
• Connect battery pack to the tray. You will see the lights on the Ethernet port
turn on.
• The Mantis Sub controller boots (~30 seconds). During booting the LED
changes from red to blue to white.
• A white LED signals that the Mantis Sub controller is ready and waiting for
connection to the Insta360 Pro/Pro2.
INFORMATION ON THE BATTERY PACK
• The battery shuttle inside the takes 3x 18650 batteries.
• A battery pack with 3x 3000mAh 18650 batteries can power the Mantis Sub
controller for up to 20 hours.
•
The battery pack can also power the Insta360 Pro/Pro2 via the extension
cable and provide up to 30 minutes of additional runtime, depending on
battery and health. This reduces the overall runtime of the controller.
PRE-DIVE CHECKLIST
1. Confirm the Insta360 Pro/Pro2 is charged and properly seated
2. Confirm the Ethernet cable is connected.
3. Confirm the Mantis Sub controller is powered on.
4. Confirm the O-ring is in place, undamaged, and free of debris.
5. Confirm the O-ring was not pinched while the housing was closed.
6. Confirm all four latches have locked securely.
7. Hold the power button for two seconds to power on Insta360 Pro/Pro2.
8. Observe display to confirm Insta360 Pro/Pro2 is ready.
9. Confirm the status LED has turned yellow to signal the controller is connected
to the Insta360 Pro/Pro2.
10. Unscrew the vacuum port cover and pump 5-6 times to create vacuum.
11. Confirm the status LED has turned green to signal vacuum is achieved.
12. Replace the vacuum port cover.
13. Press the record button and wait for the recording to start. Confirm the status
LED has turned magenta while the Insta360 Pro/Pro2 is preparing to record.
14. Confirm the status LED has turned off to not interfere with the recording.
All rights reserved. Information and specifications may change at any time without notice.
Version 2.5, 2021-06-21
6
Advertisement
Table of Contents
