Mantis SUB Owner's Manual page 12

Situation: LED blinking yellow
Reason: Vacuum too great
Resolution:
1) Remove vacuum valve screw cap
2) Press red vacuum valve button in short intervals until LED turns green.
3) Reseat vacuum valve screw cap
Situation: LED blinking Red
Reason: Vacuum lost
Resolution:
1) Resurface
2) Reseal housing using pre-flight checklist
Situation: LED blinking Green
Reason: Other controller is connected to camera (e.g. Insta App) and blocking
connection by the Mantis controller.
Resolution:
1) Disconnect Insta360 App
Situation: LED blinking Blue
Reason: Other controller is connected to camera (e.g. Insta App)) and blocking
connection by the Mantis controller.
Resolution:
1) Disconnect Insta360 App
Situation: Camera does not start recording
Reason: Camera connection error.
Resolution:
1) Repeat Camera Power Button press
2) Restart camera if problem persists
Situation: Camera does not stop recording
Reason: Camera malfunction.
Resolution:
1) Press Camera Power Button to stop recording
2) Observe viewport and wait for camera to enter ready state
3) Press Stop Recording Button (#3)
4) Restart camera if problem persists
Situation: Camera connection error persists.
Reason: Camera/Controller malfunction.
Resolution:
1) Turn off camera (Hold Camera Power Button for 3s, or 10s to force)
2) Reset controller (Press Start Recording Button 5x)
3) Restart camera (Hold Camera Power Button for 1s)
4) Wait for connection.
All rights reserved. Information and specifications may change at any time without notice.
Version 2.5, 2021-06-21
12