Table of Contents
Advertisement
• Open the browser, then navigate to
interface.
• Follow on-screen instructions to change settings.
• After changing settings, press "Save".
• The settings will be applied immediately, there is no need to reboot the
controller.
• The settings will remain in effect after reboot until changed again.
CARE AND MAINTENANCE
1. Soak the enclosure in fresh water after each salt water use, during which all
control buttons/knobs should be operated a few times to avoid the
accumulation of salt residue; wipe the enclosure with a towel before opening.
2. After each day of diving, it is advisable to have the main O-ring in the front
part of the enclosure removed from its groove and inspected for damage. Also
check that the O-ring retains its original circular shape; never stretch the O-
ring excessively or remove it with a sharp object.
3. The O-ring groove should be cleaned to ensure it is free from any salt deposit
or foreign material; lightly coat the O-ring with the provided lubricant before
reinstalling it in the groove.
4. A damaged O-ring should be discarded immediately and replaced only with
one that is provided by Mantis.
5. Replace the tow main O-rings and three dome O-rings annually.
6. It is recommended that you ship the enclosure to the factory or our distributor
for a complete overhaul every year or after every 200 dives.
RECOMMENDED CAMERA SETTINGS
While lighting conditions vary widely underwater, tests suggest that setting white
balance manually to 6500, limiting ISO to 400 and shooting with iLog switched off is
the best starting point for good results. We encourage users to experiment in their
local environment, especially if using artificial light.
TROUBLESHOOTING
All rights reserved. Information and specifications may change at any time without notice.
Version 2.5, 2021-06-21
http://192.168.43.2/
to access the control
10
Advertisement
Table of Contents
