Table of Contents
Advertisement
Available languages
Available languages
∙
Avoid blank shots in order to reduce the wear of
the impact strike.
∙
Never leave the loaded tool unattended!
∙
Always switch off the device and pull the power
plug, whenever the tool is not being used, before
carrying out any maintenance work, before changing
staples or nails or before removing jammed staples or
nails.
UNPACKING
When unpacking, check to make sure that all
components are included. Refer to the drawings on this
manual. If any parts are missing or broken, please call
an IVT assistance center.
INSERTING STAPLES AND NAILS [F1]
1.
Switch the tool off and pull the power plug.
2.
Extract the magazine (3).
3.
Put nails or staples into their slot.
4.
Slide the magazine (3) back, until it stops and
snaps noticeably into place.
NOTE: when inserting a nail strip, tilt the tool in such
a way, that the nail strip rests against the side of the
magazine (3) which corresponds with the nail symbol
on nailer head (4).
INITIAL OPERATION
Always use the correct supply voltage: the power supply
voltage must match the information quoted on the tool
identification plate.
SWITCHING ON / OFF [F2]
Switching on
1.
Put the On/Off switch (2) on «ON» position. The
tool is now ready for operation.
2.
Firmly press nailer head (4) against the workpiece
until it is pushed in a few millimeters.
NOTE: the trigger switch (1) is locked as long as nailer
head (4) is not pressed against the workpiece, thus
preventing accidental operation.
3.
Push the trigger switch (1) to shoot a staple or a
nail.
ATTENTION! DO NOT ATTEMPT TO REPAIR THE PRODUCT BY YOURSELF AND DO NOT
TAMPER WITH IT! Any operation of repairing or extraordinary maintenance must be carried
out only by a qualified and authorized IVT Service Center. Do not try to modify any internal
part of the product! THIS WILL COMPLETELY VOID THE WARRANTY AND IT COULD CAUSE
SERIOUS INJURY AND DAMAGE.
Avoid operating the trigger switch (1) if there are no
staples or nails in the magazine (3).
Switching off
1.
Press the On/Off switch (2) on «OFF» position.
If the electric nailer is not in operation – even for
short periods – switch off the tool with the On/Off
switch (2) to prevent any unintentional operation.
Remove all staples or nails from the magazine (3)
after each use.
MAINTENANCE AND STORAGE
Before any work on the device itself,
pull the mains plug.
∙
Always keep the tool and the ventilation slots (if
present) cleaned. Regular cleaning and maintenance of
the appliance will ensure efficiency and prolong the life
of your tool.
∙
If the tool should fail despite the rigorous
manufacturing and testing procedures, the repair should
be carried out by an authorized IVT customer service.
∙
Keep all nuts, bolts, and screws tight, to be sure the
tool is in safe working condition.
∙
Replace worn or damaged parts for safety.
∙
Use only original spare parts. Parts not produced
by manufacturer may cause poor fit and possible injury.
∙
Store the tool in a dry room out of reach of kids and
away from any flammable material.
∙
Never wet the device or spray water on it!
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of
disposing as waste.
Tool, accessories and packaging should be sorted for
environment-friendly recycling.
The plastic components are labeled for categorized
recycling. These instructions are printed on recycled
paper manufactured without chlorine.
9
Instruction manual
EN
Advertisement
Table of Contents
