Mounting Instructions; Installation Instructions For Geared Motors - Siemens Simotics Operating Instructions Manual

Mounting

4.3 Mounting instructions

4.3 Mounting instructions
4.3.1

Installation instructions for geared motors

Note
Observe the technical data on the rating plate attached to the gearbox housing and the
motor
• Observe the data on the rating plate, as well as the warning and information plates on the
motor.
• Check the permissible ambient conditions (e.g. temperature, installation altitude) at the
installation location.
Their use is prohibited in hazardous zones.
• Thoroughly clean the shaft extension of corrosion protection. Use commercially available
solvents.
• Ensure sufficient dissipation of heat. Information on this topic can be found in the
Operating Instructions of the motor.
• If the motor is installed vertically with the end of the shaft facing up, ensure that no liquid
can enter the upper bearing.
• Ensure that the flange is in even contact with the mounting surface.
• Do not use cylinder head screws.
• When tightening the fastening bolts avoid any uneven stressing.
• Observe the tightening torques of the fastening bolts. See table "Tightening torques for
fastening bolts".
38
Planetary gearboxes for servomotors
Operating Instructions, 09/2020, A5E50494253B AA