Table of Contents
Advertisement
2. WIRING
2. Unfasten the binding screws (indicated in the following figure) to remove the cable
clamp from the trackball control unit, then disconnect the control unit cable from
J1.
Cable clamp
3. Pull out the control unit cable from the cover.
4. Pass the optional cable assembly (6TPSH-XH12X2-LxxSP2) through the cable
hole on the cover.
5. Fasten the shield of the cable assembly with the cable clamp (removed at step 2),
then connect the connector at the end of the cable assembly to the J1 connector
on the circuit board.
Note: The shield of the cable must not touch the circuit board.
Cable assembly
6. Reattach the control unit cover.
2.4
Transducer
The transducer with a cable diameter 22.0 mm should be installed. Check that the
data sheet sticker on the transducer cable is in silver.
2-10
Binding screw
J1
Disconnect this connector.
Cable assy
(6TPSH-XH12X2-LxxSP2)
Shield
Cable clamp
Circuit board
Advertisement
Table of Contents
