Troubleshooting - TEFAL Express Protect SV92 Manual

TROUBLESHOOTING

Problem
Your iron is
producing
little or no
steam.
Water runs
out of the
holes of the
soleplate.
Possible Causes
You have just filled the
tank or changed the
anti-calc cartridge, or
you have just started
using it.
There is no anti calc
cartridge in the
appliance or it is not
properly installed.
Steam cannot be
produced at the
temperature you
have selected.
The water tank is empty.
You are using steam
for the first time or
you have not used it
for some time.
The setting is not
correct (1 dot / 2 dots)
and the soleplate is
not hot enough to
produce steam.
You are performing
the Anti calc
procedure.
34
Solutions
Press the steam control
button continuously for
few minutes pointing it
away from your linen, in
order to prime the pump.
Make sure the anticalc
cartridge is installed
and locked in its
compartment.
Set the thermostat
control in the coloured
zone (••• or MAX).
Fill the tank.
Press on the steam
control button away from
your ironing board until
the iron produces steam.
Set the iron at 3 dots (•••
or MAX) and wait for the
iron thermostat light to
go out before activating
the steam button again.
It is normal that water
runs out of the holes
of the soleplate during
Anti calc procedure.