Unit Connectors - Axis 211W User Manual

Unit connectors

Antenna connector - Reverse SMA connector for antenna.
Network connector - auto-MDIX, RJ-45 Ethernet connector. Using shielded cables is recommended.
Power connector - Mini DC connector. 7 - 20V DC, max 5W. See product label for
Audio in - 3.5mm input for a mono microphone, or a line-in mono signal (left channel is used from a stereo
signal).
Audio out - Audio output (line level) that can be connected to a public address (PA) system or an active speaker
with a built-in amplifier. A pair of headphones can also be attached. A stereo connector must be used for the
audio out.
I/O terminal connector - Used in applications for, e.g. motion detection, event triggering, time lapse recording
and alarm notifications
LED Indicators
After completion of the startup and self test routines, the multi-colored Wireless, Network, Status, and Power
LED indicators show as follows:
LED
Wireless
Network
Status
Power
AXIS 211W - Product Features
Color Indication
Green Steady for connection to a wireless network. Flashes for network activity.
Red Steady for no wireless network connection. Flashes when scanning for wireless net-
works.
Unlit Wired mode.
Green Steady for connection to a 100 Mbit/s network. Flashes for network activity.
Amber Steady for connection to 10 Mbit/s network. Flashes for network activity.
Unlit No network connection.
Green Steady green for normal operation.
Note: The Status LED can be configured to be unlit during normal operation, or to
flash only when the camera is accessed. To configure, go to Setup > System
Options > LED settings.
Amber Steady during startup, during reset to factory default or when restoring settings.
Red Slow flash for failed upgrade.
Green Normal operation.
Amber Flashes green/amber during firmware upgrade.
7
connection.
±