Brinkmann ProSeries 2500 Owner's Manual page 25

Screw Holes
Step 9
Attach side burner assembly to grill
body assembly by inserting four
M6 X 20mm bolts halfway into the
screw holes of the grill body
assembly. Then slide side burner
assembly onto bolts and secure all
four bolts. Install side burner grate
and control knob.
Side burner grate
SIDE BURNER LIGHTING INSTRUCTIONS:
1. Read and follow all warnings and instructions
in owner's manual before lighting.
2. Open lid before lighting side burner.
3. Make sure all control knobs are in the OFF position.
4. Push and turn side burner control knob of that burner to HIGH.
5. Press the electronic igniter and hold for 3-5 seconds
to light burner.
Step 10
Remove the plastic cap on gas
supply manifold and attach rubber
gas hose to gas supply manifold.
Hand tighten first, then use
supplied wrench to turn brass nut
an additional 1/8 turn.
Important: Do not overtighten.
This could damage
brass fitting.
Warning: Never use your grill
without leak testing all
gas connections and
hoses. See the section
on "Leak Testing" in this
manual for proper
procedures. (See page 7)
MAXIMUM SIDE BURNER LOAD = 15 lbs.
24