Extreme Networks ExtremeSwitching SLX 9150 Hardware Installation Manual page 53

Installing Your Switch
6. Connect the AC power cord.
a. If necessary, slide the plastic cord retainer farther away from the back of the switch.
b. Connect the AC power cord to the input connector.
c. Open the clip and slip it over the barrel of the connector.
The diagram below - Power Supply with Power Cord and Retainer Attached shows the power
supply with the power cord and retainer in place.
Figure 27: Power Supply with Power Cord and Retainer Attached
d. Snap the clip firmly around the connector.
7. Connect the other end of the power cord to an AC power outlet.
To install a second power supply, repeat this procedure.
When you are finished, follow the steps in
Warning
Always make sure that the source outlet is properly grounded before plugging the AC
power cord into the AC power supply.
ExtremeSwitching SLX 9150 Hardware Installation Guide
Installing a 750 W Internal AC Power Supply
Powering up the Switch on page 58 .
53