Siemens Synco 700 Operating Instructions Manual page 47

Entering additional heating periods
1. Select the required day.
2. In the diagram, advance pointer
in time of the current program.
3. Turn the OK knob by one notch;
––:–– –––––– appears.
4. Set the required start time.
5. Select the required room operating mode.
Copying a 24-hour heating program
1. Select the day to be copied.
2. Turn the OK knob in clockwise direction until Copy to:
appears.
3. Press the OK knob.
4. The menu with the selection of days (week section,
individual weekdays, special day) appears.
5. Select the required weekday or week section.
6. Copy (press the OK knob).
First, prepare a 7-day schedule for the daily heating periods and setpoints – this will facilitate entry into the controller!
Building Technologies / HVAC Products
to the last point
CE1B3133x2-en
New 24-hour program
The controller is supplied with a 24-hour program for
every day (including the special day). This means that
you will never have to create a new 24-hour program,
but only change an existing program.
Power off – heating program lost?
In the event of a power failure, the 24-hour programs
entered will be maintained, independent of the duration
of the power failure.
74 319 0560 0 a
11
10.10.2006