Often Used Features; Last Number Dial; System Speed Dial; Saved Number Dial - AT&T MLC-5 Supplementary Manual

OFTEN USED FEATURES

Last Number Dial

To program:
1.
Label a button.
2.
Slide T/P switch to P.
3. Press button to be
programmed.
4.
Dial 84.
5.
Slide T/P switch to center.
To use:
1.
Press the same type of
button used to place the
first call, (for example,
ICOM or SA).
2.
Press programmed button,
or press Feature or # and
dial 84. (Before using #
sign, you must lift handset.)
Paging
To program speakerphone
paging button:
1.
Select a non-line or non- SA
button to program.
2.
Slide T/P switch to P.
3.
Press labeled button.
4.
Dial 22 and Group Page
or Page All extension.
5.
Slide T/P switch to center.
To use speakerphone paging:
1.
Press an ICOM or SA button.
2.
Press On/Off.
3. Press programmed button
and, dial company-provided
Group Page or Page All
number .
4.
Make announcement after
beep.
To use loudspeaker paging:
1.
Press On/Off.
2.
Press programmed button,
or press Feature and dial 9
and Loudspeaker Page
line number.
3.
Dial code for company-
defined zone if necessary.
4.
Make announcement.

System Speed Dial

Use company-programmed 3-digit
codes to dial phone numbers. Ask
your system manager for a list of
numbers and their associated
codes.
To program:
1.
Label a button.
2.
Slide T/P switch to P.
3. Press button to be programmed.
4.
Dial 24 .
5. Dial 3-digit company-
supplied speed dial code.
6.
Slide T/P switch to center.
To use:
Press On/Off. Then press
programmed button, or dial
#, and dial 3-digit company-
supplied speed dial code.

Personal Speed Dial

Program 2-digit codes with numbers
you dial most often, then use feature
button to use these codes to dial a
number.
To program personal speed
dial codes:
1.
Slide T/P switch to P.
2.
Dial # and 2-digit
code (01 -24), then dial
3.
Dial phone number or
account number. (Include
entire dialing sequence, for
example, dial-out code.
Special characters may be
needed (See Special
Characters Table).
4.
Repeat Steps 2 and 3 to
program additional
codes.
5.
Slide T/P switch to center.
To use:
1.
Press On/Off.
2.
Dial # and a 2-digit code (01-
24).

Saved Number Dial

To program:
1.
Label a button.
2.
Slide T/P switch to P.
3. Press button to be
programmed.
4.
Dial 85.
5.
Slide T/P switch to center.
To save and redial:
1.
Press programmed button
before hanging up.
2.
To redial call, press same
type of button used place
the call (ICOM or SA).
3.
Press programmed button.
Special Characters Table
Features that dial numbers
automatically may need special
characters to allow for correct
dialing or system response.
Press... Means...
Hold Pause. Inserts 1.5 sec. pause
in dial sequence. Multiple
consecutive pauses allowed.
## For Extension Programming
only: End of Dialing. Used to
21.
signal end of dialing
sequence or used to
separate grouped digits, for
example, account codes
from number dialed.
# End of Dialing. Used to
signal end of dialing sequence
or used to separate grouped
digits, for example, account
codes from number dialed.