AT&T Merlin Legend 10BS Quick Reference page 2

BRI Access Button Quick Reference
CO Transfer
With the CO Transfer feature using BRI lines, your line is available following the completion of the transfer
and is not used for the duration of the call,
Procedure
To transfer a call outside of the MERLIN LEGEND system using the BRI Access button:
1. While a call on a BRI line is in progress, press the
The call is placed on hold, The system automaticalfy selects a System Access (SA) or Intercom (ICOM)
Voice or Ring button.
2.. Press the BRI Access button, The red and green LEDs next to the BRI Access button lights,
The green LED next to the line button with the held call flutters to indicate the call is on hold, You receive
a dial tone. The caller outside being transferred hears silence while the call is being connected,
3. Dial the outside telephone number,
Note: Do not use Automatic Route Selection (ARS) or pool dial-out code to dial the outside number.
Depending on your CO, you may need to dial 9 to access an outside line.
— If you receive no answer or a busy signal at the destination telephone number you can return to the
call being held for transfer by pressing the line button associated with that call. This action removes
the transfer request and connects you with the origins/ call.
4. When the destination party answers the call, press the
— Depending on your CO, the party to receive the transferred call, may need to answer or the call may
be disconnected,
The LEDs next to the BRI line and the BRI Access button go off to indicate that both line buttons are
available for use.
button,
Transfer
button or hang up to complete the transfer,
Transfer