Motorola O2 Manual page 9

1. Plug the power adaptor into the socket marked
charger and plug the other end into the mains power wall socket.
2. The 750mAh Ni-MH battery pack is pre installed. If you are charging the
batteries for the first time, place the handset on the charger to charge for
at least 16 hours continuously.
3. When the handset is fully charged,
display. The display will show the time and handset number (e.g. 2)
to indicate that it is registered to the base. Plug the other end of the
telephone line cord (make sure that one end is already plugged into the
base) into the telephone wall socket.
Replacing the handset battery
1. Unscrew the belt clip, then unscrew the 4 screws on the battery cover (the
screws will stay attached to the battery compartment door) from the back
of the handset and plug in the 750 mAh Ni-MH rechargeable battery pack
supplied.
2. Replace the battery cover and screw the cover into place. Finally, screw the
belt clip on.
Important
Warning! Use only the approved rechargeable Ni-MH battery pack (750mAh
Ni-MH rechargeable battery pack) supplied with your O2.
Battery low
If icon is displayed and you hear a warning beep every 30 seconds during a
call, you will need to recharge the handset before you can use it again. When
charging, icon will scroll on the display.
Getting started
P
on the underside of the
icon will appear steady on the
9