Ensure there is adequate fall clearance when working at height. Never modify or alter your fall protection equipment. Only 3M or parties authorized in by 3M may make repairs to the equipment. Prior to use of fall protection equipment, ensure a rescue plan is in place which allows for prompt rescue if a fall incident occurs.
; If you have questions on the use, care, or suitability of this equipment for your application, contact 3M Fall Protection. For general questions, refer to national Standards including the ANSI Z359 (.0, .1, .2, .3, and .4) family of standards on fall protection, ANSI A10.32, and applicable local, state, and federal (OSHA) requirements governing occupational safety for more information about fall protection systems.
PRODUCT APPLICATION PURPOSE: Anchorage Systems are designed to provide anchorage connection points for a Personal Fall Arrest System (PFAS). SUPERVISION: Installation of this equipment must be supervised by a Qualified Person . Use of this equipment must be supervised by a Competent Person TRAINING: This equipment must be installed and used by persons trained in its correct application.
Page 8
3M connectors (snap hooks and carabiners) are designed to be used only as specified in each product’s user’s instructions. See Figure 6 for examples of inappropriate connections. Do not connect snap hooks and carabiners: To a D-ring to which another connector is attached.
; Mounting brackets must be purchased from 3M Fall Protection or designed by a qualified person representing the certified installer. ; Contact 3M Fall Protection if you have questions regarding any phase of Glyde-Saf HD Fall Arrest System installation or use of the system.
Page 10
Fall Arrest System. ; Only 3M Fall Protection or parties authorized in writing by 3M Fall Protection may make repairs to this equipment. PrOdUCT LIFE: The functional life of the System is determined by work conditions and maintenance. As long as the product passes inspection criteria, it may remain in service.
Page 11
The following labels must be present on each Trolley Rail and End Stop in the FlexiGuard Glyde-Saf HD Fall Arrest System. Labels must be replaced if they are not fully legible. Contact 3M Fall Protection for replacement labels. 9509771 Rev. A 9509772 Rev.
Page 12
IMPORTANT: Extreme working conditions (harsh environment, prolonged use, etc.) may require more frequent inspections. If you have questions on the use, care, or suitability of this equipment for your application, please contact 3M Fall Protection. Corrective Action/Maintenance: Approved By:...
Page 14
LIMITED REMEDY: Upon written notice to 3M, 3M will repair or replace any product determined by 3M to have a factory defect in workmanship or materials. 3M reserves the right to require product be returned to its facility for evaluation of warranty claims. This warranty does not cover product damage due to wear, abuse, misuse, damage in transit, failure to maintain the product or other damage beyond 3M’s control.