Hot-Air Pressure, Hot-Sealing Temperature, -Pressure And -Speed - Pfaff 8304-040 Instruction Manual

9

Hot-air pressure, hot-sealing temperature, -pressure and -speed

.04
Fig. 9 - 06
● Switch the machine on.
Hot-air pressure:
● Adjust hot-air pressure on regulator 1 depending on the workpiece (at least 0.3 bar).
● To adjust the hot-air pressure on regulator 1 first set the pressure at "0". Then adjust
regulator 1 to the required level.
Heat-sealing temperature:
● Adjust the heat-sealing temperature on the buttons 2 depending on the material (max.
650°C).
● Display 3 shows the required temperature and display 4 the actual temperature.
Heat-sealing speed and feed roller pressure:
● The heat-sealing speed and feed roller pressure depend on the material and can be
adjusted as described in Chapter 7.07 or 7.10.
1
Before switching the main switch on, make sure that the hot-air pressure is
higher than 0.2 bar!
If the hot-air pressure is too low, the heating switches off automatically.
4
3
Fig. 9 - 07
Setting up
2
9 - 4