Advertisement
If your system has been selected for Custom Code manual override as indicated on the last
page of this manual, in order to provide the highest level of security, this system will allow you
to program your personal manual override code. This code is a ( 2 ) digit code. The first digit
must be a digit from 1 through 9, and the second digit must be either 1, 2, or 3.
To program your access code, the security system must be in the disarmed state. Once dis-
armed, program your code as follows;
1. Turn the ignition key on, then off, then on.
2. Within 3 seconds of step 1, flip the Valet switch on, then off. The siren will sound
one short chirp, followed by one long chirp. This indicates that the system is in the
manual override programming mode.
3. The red dash L.E.D. will begin to count by flashing. Allow the L.E.D. to flash until
it gets to the first digit of your selected code.
4. As soon as the L.E.D. turns on for the corresponding number of your first digit,
quickly turn the ignition key;
1. off then on for second digit 1
2. off then on twice for second digit 2
3. off then on three times for second digit 3.
5. The siren will sound one short chirp, followed by one long chirp, indicating that the
code has been memorized.
6. After a 2 second pause, the L.E.D. will flash confirmation of the stored code,
beginning with the first digit, then a pause, then the second digit.
EXAMPLE : To program the manual override code 52, you would;
1. Turn the ignition key on, then off, then on.
2. Within 3 seconds of step 1, flip the Valet switch on, then off. The siren will sound
one short chirp, followed by one long chirp. This indicates that the system is in the
manual override programming mode.
3. Allow the L.E.D. to flash 5 times, and during or immediately after the fifth flash,
quickly turn the ignition key to off, then on, then off, then on.
4. The siren will sound one short chirp, followed by one long chirp, indicating that the
code has been memorized.
5. After a 2 second pause, the L.E.D. will flash 5 times, then pause, then flash 2
times. This confirms that the code 52 has been stored into memory.
USING THE CUSTOM CODE MANUAL OVERRIDE
It is very important that you understand how to operate the manual override feature, as there
may a time that you will need to bypass the alarm when your transmitter is not working. You
should also write down your personalized code number, and keep it in a safe place for future
reference.
To by pass the alarm,
1. Open the door. The alarm will sound.
2. Turn the ignition key to the on position. The alarm will stop for three seconds, then
the siren will begin counting with long chirps.
3. As soon as the chirp that corresponds with your first digit sounds, quickly turn the
ignition key ;
1. off then on if your second digit is 1
2. off then on twice if your second digit is 2
3. off then on three times if your second digit is 3.
Page 5
Advertisement
