Transmission Tightening Specifications - Volkswagen Golf 2015 Repair Manual

Golf 2015 ➤ , Golf Variant 2015 ➤
Manual Transmission - Edition 02.2016
– Connect the connector -1- to the Oil Level Thermal Sensor -
G266- .
– Gear oil level in manual transmission, checking. Refer to
⇒ 8.1 Transmission Fluid Level, Checking , page 142
– If unclipped, carefully clip in the A/C system pipe and do not
disconnect the line system. Refer to ⇒ Heating, Ventilation
and Air Conditioning; Rep. Gr. 87 ; Refrigerant Circuit; System
Overview - Refrigerant Circuit .
– Install the battery tray, battery and the battery cover. Refer to
⇒ Electrical Equipment; Rep. Gr. 27 ; Battery; Battery Tray,
Removing and Installing .
– Install the air filter housing. Refer to ⇒ Engine Mechanical,
Fuel Injection and Ignition; Rep. Gr. 24 ; Air Filter; Air Filter
Housing, Removing and Installing .
– Install the engine cover. Refer to ⇒ Rep. Gr. 10 ; Engine
Cover; Engine Cover, Removing and Installing .
– Install the lower section of the left front wheel housing liner.
Refer to ⇒ Body Exterior; Rep. Gr. 66 ; Wheel Housing Liner;
Front Wheel Housing Liner, Removing and Installing .
– Install the noise insulation. Refer to ⇒ Body Exterior; Rep. Gr.
66 ; Noise Insulation; Overview - Noise Insulation .
2.3

Transmission Tightening Specifications

Item
1 M12 x 55
♦ With a long M8 threaded pin
2 M12 x 55
♦ With a short M8 threaded pin or
M12 x 50
♦ Without threaded pin
3 M12 x 165
♦ With an M8 threaded pin
♦ Also starter to transmission
4 M10 x 105
5 M10 x 50
6 M12 x 70
or M12 x 65
-
♦ Small flywheel cover plate (not present
on all engines)
-A- Alignment sleeves for centering
104
Rep. Gr.34 - Controls, Housing
Bolt
M6 x 8
.
Quantity Nm
1 80
1 80
2 80
1 40
2 40
1 80
1 10