Disarming The System; Silent Disarming - Audiovox Pursuit PRO-9744WOS2 Owner's Manual

Remote alarm with selectable pre-load features pursuit series
Table of Contents

Advertisement

light will also flash during the triggered mode. A trigger mode will continue for 30
seconds, the alarm will reset, and continue to monitor your vehicle. If the thief
left a door opened, the triggered mode will continue for six 30 second cycles,
after which, the open door (zone) will be isolated and the system will continue to
monitor all other zones. Whenever the system is armed any strong impact to the
vehicle will cause the shock detector to trigger the alarm system.
Whenever the system is armed, the dash mounted LED will slowly flash. This
serves as a visual deterrent to a potential thief. This LED is a very low current
light emitting diode which will not cause the vehicle's battery to drain even if the
vehicle is left unattended for long periods of time.
Whenever the system is armed, the vehicle starting system is disabled, the ve-
hicle cannot be started even with the ignition key.

DISARMING THE SYSTEM:

As you approach the vehicle, press and release the transmitter button with the
open lock symbol on it. The parking lights will flash two times, the Horn or Siren
will beep or chirp twice, and the dash mounted LED will turn off.
If you have the optional door lock/unlock circuit installed, the doors will unlock. If
you have the optional entry illumination circuit installed, the interior light will turn
on for 20 seconds or until the ignition switch is turned on.
NOTE: If the passive arming mode was selected at time of installation, the LED
will begin to flash rapidly indicating that the system is re-arming. Opening any
door will suspend the automatic arming cycle.
If, when you disarmed the system, the parking lights flashed three times, and the
Horn or Siren beeped or chirped four times, this indicates that the alarm system had
been triggered in your absence. Before turning on the ignition switch, examine the
dash mounted LED's flash pattern. The number of flashes will identify the violated
zone. For additional information, refer to the "Intrusion Warning Signals" shown
later in this manual. If upon disarm, the Horn or Siren did not beep or chirp two
times, refer to the section entitled "Eliminating The Arm/Disarm Beeps or Chirps".

SILENT DISARMING:

As you approach the vehicle, press and hold the transmitter button with the
open lock symbol on it for two seconds. The parking lights will flash two times,
and the dash mounted LED will turn off. If you have the optional door lock/unlock
circuit installed, the doors will unlock. If you have the optional entry illumination
circuit installed, the interior light will turn on for 20 seconds or until the ignition
switch is turned on.
NOTE: If the passive arming mode was selected at time of installation, the LED
will begin to flash rapidly indicating that the system is re-arming. Opening any
door will suspend the automatic arming cycle. If the parking lights flashed three
times, and the Horn or Siren beeped or chirped four times, this indicates that the
alarm system had been triggered in your absence. Before turning on the ignition
switch, examine the dash mounted LED's flash pattern. The number of flashes
identifies the violated zone. For additional information, refer to the "Intrusion
-5-

Advertisement

Table of Contents
loading

Table of Contents