Disc Removal Method At No Power Supply; Parental Control - Rating Level; Tray Lock; Preparation Of Servicing - Toshiba VTD1431 Service Manual

DISC REMOVAL METHOD AT NO POWER SUPPLY

1. Remove the Back Cabinet and AV PCB/DVD Block. (Refer to item 1 of the DISASSEMBLY
INSTRUCTIONS.)
2. Slide the Rack Loading (White) toward the arrow direction by using a minus driver to release the lock.
(Refer to Fig. 1)
3. Draw the Tray.
If the stored 4 digit password in the Rating Level menu needs to be cancelled, please follow the steps
below.
1. Turn Unit ON.
2. Press and hold the 'STOP' key on the front panel.
3. Simultaneously press and hold the '7' key on the remote control unit.
4. Hold both keys for more than 3 seconds.
5. The On Screen Display message 'PASSWORD CLEAR' will appear.
6. The 4 digit password has now been cleared.
NB: The above procedure will reset ALL of the player's settings to the default factory state.
Tray cannot be opened by setting the Tray Lock, please follow the steps below.
1. Turn Unit ON.
2. Set the DVD to the Stop Mode.
3. Press and hold the 'STOP(DVD)' key on the front panel.
4. Simultaneously press and hold the '9' key on the remote control unit.
5. Hold both keys for more than 3 seconds.
6. Press the OPEN/CLOSE key on the front panel to check the Tray Lock setting.
NB: No indications on the screen when the Tray Lock is setting.
To unlock the Tray Lock, please follow the steps below.
1. Turn Unit ON.
2. Set the DVD to the Stop Mode.
3. Set the VOLUME to minimum.
4. Press and hold the 'VOL.DOWN' button on the front panel.
5. Simultaneously press and hold the '4' key on the remote control unit.
6. Hold both keys for more than 2 second.
7. The On Screen Display message 'INITIALIZE7 COMPLETE' will appear.
8. The Tray Lock has now been cleared.
NB: The above procedure will reset ALL of the player's settings to the default factory state.
The laser diode used for a pickup head may be destroyed with external static electricity.
Moreover, even if it is operating normally after repair, when static electricity discharge is received at the time of repair, a life of
product may become short.
Please perform the following measure against static electricity, be careful of destruction of a laser diode enough at the time of repair,
and work.
• It works on the desk which performed measures against static electricity, such as conductive mat.
• Soldering iron with ground wire or ceramic type is used.
• A worker needs to use a ground conductive wrist strap for body.

PARENTAL CONTROL - RATING LEVEL

4 DIGIT PASSWORD CANCELLATION

TRAY LOCK

PREPARATION OF SERVICING

Rack Loading
(White) Deck CD
Fig. 1
A1-2