Quick Reference Chart; Valet Switch; Battery Replacement - Audiovox Prestige APS-2K4MS Programming Manual

reprogrammed. Any other transmitter stored in the unit's memory still
remain operational. If the button is released and not pressed again within
the 5 second period, no change in programming has been made to the
receiver channel. The programmer can move onto a different channel or
erase the transmitter codes as described in 1 above.

QUICK REFERENCE CHART:

You can program any individual channel without reprogramming all
channels. To go directly to a particular receiver channel follow the
chart below:
CHANNEL
1 Ign. On Then
Press and Release 3 Times
2 Ign. On Then
Press and Release 4 Times
3 Ign. On Then
Press and Release 5 Times
4 Ign. On Then
Press and Release 6 Times
5 Ign. On Then
Press and Release 7 Times
6 Ign. On Then
Press and Release 8 Times

BATTERY REPLACEMENT:

The transmitter incorporates a small LED visible through the case which
is used to indicate battery condition. You will notice a decrease in
transmitter range as the battery condition deteriorates. Transmitter
battery replacement is recommended at least every 10 to 12 months,
depending upon how frequently the transmitter is used.
To replace the battery:
1) Remove the small # 0 phillips head screw from the rear of the case.
2) Remove the rear cover to access the discharged battery paying
attention to the proper polarity orientation.
3) Carefully remove and properly dispose of the discharged battery.
4) Insert the new battery, close the
case, then reinstall the small case
screw removed in step 1.
5) If you accidently dislodge the circuit
board from the transmitter housing,
be certain that the rubber membrane
is seated properly, and the buttons
are properly exposed from the front
view of the case, then insert the
circuit board, and return to step #4.

VALET SWITCH

5
LED
1 Flash
2 Flashes
3 Flashes
4 Flashes
5 Flashes
6 Flashes