6088 (RM218)
Baseband Description and Troubleshooting
Mobile Terminal is Dead
Mobile
Terminal is
Dead
Is the mobile
terminal current is
zero or too high?
NO
Is the current
< 60 mA?
YES
Check RESET_N
signals. Is it high
(2.8V)?
YES
Check PS_HOLD
signals. Is it high
(2.9V)?
NO
Check ROM_CS_N
(TP72). Is it toggling
after RESET_N goes
high?
NO
MSM6025 is defective,
phone cannot be repaired
and must be replaced.
Page 30
© 2006 Nokia Corporation
♦
If current is zero, check L101, L1011, Q400,
R851, F1 and check the power on sequence.
If there is no power output, Reheat solder
joints or change PM6610.
♦
YES
Make sure all BB regulators are at their respective
voltage levels (VREG_MSMA, VREG_MSMP,
VREG_MSMC, VREG_TCXO). Reheat solder
joints / change PM6610 if necessary.
Check J101, C108 and
R110.
NO
Are they OK?
YES
Reheat solder
joints , check R836
NO
or change PM6610
Is flash memory
YES
programming OK?
YES
Memory IC is
defective, phone can
YES
not be repaired and
must be replaced.
Reheat solder joints /
NO
defective, phone can
not be repaired and
must be replaced.
Flash
Memory
NO
Faults
Terminal is
Jammed
Company Confidential
change PM6610.
MSM6025 is
Mobile
Issue 1 10/2006