Safety Precautions (English); Before Supplying Power To The Inverter - Westinghouse Teco E510 Instruction Manual

Table of Contents

1. Safety Precautions (English)

The main circuit must be correctly wired. For single phase supply use input terminals (R/L1, T/L3) and for

three phase supply use input terminals (L1(L), L2, L3(N)). Terminals T1, T2, T3 must only be used to

connect the motor. Connecting the input supply to any of the T1, T2 or T3 terminals will cause damage to

the inverter.



To avoid the front cover from disengaging or other physical damage, do not carry the inverter by

its cover. Support the unit by its heat sink when transporting. Improper handling can damage the

inverter or injure personnel, and should be avoided.



To avoid the risk of fire, do not install the inverter on or near flammable objects. Install on

nonflammable objects such as metal surfaces.



If several inverters are placed inside the same control panel, provide adequate ventilation to

maintain the temperature below 40°C/104°F (50°C/122°F without a dust cover) to avoid

overheating or fire.



When removing or installing the digital operator, turn off the power first, and then follow the

instructions in this manual to avoid operator error or loss of display caused by faulty connections.

This product is sold subject to IEC 61800-3. In a domestic environment this product may cause radio

interference in which case the user may need to apply corrective measures.

Downloaded from Dealers Industrial Equipment -- Visit

Warning

Caution

Warning

1-1

https://DealersElectric.com

or call (908) 688-1966 for all of your Teco needs!

Table of Contents