Handsfree Operation; End-To-End Signaling - Audiovox CTX3600A User Manual

Note(2): In the restricted mode, a short beep tone
will be heard to infOI1Il you of the improper
operation, and the word I Restricted lwill
be shown on the readouL
TM
Touch Tone from Memory
DTMF signaling by repertory dialing is available while
engaged in a telephone conversation.
1. Press ;R~t;, and ;~).: again, then enter the repertory
memory address (01 through 99). The last 10 digits
of the number will appear on the readout.
HANDS-FREE OPERATION
(NAM OPTION)
Note: However, if the memory address entered has
been set as a secret memo .
will be di&
played on umber.
2. Press. Then DTMF signaling will be placed
and e tone can be monitored through the
loudspeaker.
This featurepenIlits you to engage in a conversation
without lifting the handset.
1. After receiving a call (press i~; or any digit
key to answer), conduct the conversation via the
hands-free microphone with the handset on the
cradle. To converse more naturally:
a. Speak in a normal tone.
b. Turn off the radio or stereo and close the car
---windows; .c~
2. To place a call, enter the phone number, then
press ~. The microphone will be turned on,
ready for conversation when your party answers.
3. After a call is completed, press ~ to tenninate
the call.
Note: If you hear feedback on a bad RF Channel,
adjust the hands-free loop attenuation as
follows.
1) Press ~, key fm] then ~. Hands-free
loop attenuation vnn be increased by 14
dB.
2) To return to the normal condition. Press
00 , key [1] then fJ].
END-TO-END SIGNALING
Note: Continuous DTMF from keypad can be manual-
ly dialed as well to access answering machines
when efigagedin a telephone call.
Link Dialing
(Includes Secret Memory Locations)
This feature permits you to pre-set from repertory
memory or the keypad up to five numbers before
placing a call. With this feature, the first number is
sent in digital form to the cell site. Then up to four
other numbers can be sent with DTMF signaling by
simply pressing for each additional number.
Note(l): Each number to be linked may be recalled
from memory or entered by keypad.
Note(2): Each number to be linked should be within
16 digits including linking mark "=" at the
end.
Note (3) : Linked number can be stored in the memory.
However, the total number of digits must be
less than 16 digits. The number of more than
16 digits should be stored into memory
-address96 through 99.
This feature perrnitsyou to utilize additional phone
services, such as accessing an alternate long
distance network; signaling apager,-or banking by
phone etc.. For these services the signaling sh~uld
be in DTMF crouch Tone1M). The following two
feature will make it easier to send in DTMF codes.
Example: To access the alternate long distance seIVice
using a secret ~umber, you should call your
long distance seIVice office first, and enter
your ID number, then the phone number to
be placed.
Note: When you use this feature with a secret
number, the number must be previously
stored in a memory address. (Refer to "To
Store the Secret Number".)
1. Recall the phone number of the long distance
service office.
Press "'~t: , then enter the memory address (01
through 90 and
24