Advertisement
Available languages
Available languages
Caution
-
Use, charge and store the appliance at a
temperature between 5°C and 35°C.
-
Only use the adapter and the charger supplied.
-
Never immerse the charger in water nor rinse
it under the tap.
-
If the appliance is subjected to a major change
in temperature, pressure or humidity, let the
appliance acclimatise for 30 minutes before
you use it.
-
If the adapter or charger is damaged, always
have it replaced with one of the original type in
order to avoid a hazard.
-
Do not use the appliance when the shaving
unit or the trimming comb is damaged or
broken, as this may cause injury.
-
This appliance is only intended for shaving and
trimming body parts below the neckline. Do
not use it to shave or trim facial or scalp hair.
Compliance with standards
-
The appliance complies with the internationally
approved IEC safety regulations and can be safely
used in the bath or shower (Fig. 2).
-
This Philips appliance complies with all standards
regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in
this user manual, the appliance is safe to use
based on scientific evidence available today.
Charging
Charge the appliance for at least 10 hours before
you use it for the first time and after a long period
of disuse.
Charging normally takes approx. 8 hours.
When the appliance is fully charged, it has an
operating time of up to 50 minutes.
When the charging light lights up orange, the
battery is running low (approx. 10 minutes of
operating time left) and you need to recharge the
appliance.
Note: The appliance can only be charged in the charger.
Switch off the appliance before you charge it.
1
Insert the small plug into the charger (Fig. 3).
2
Note: The small plug is easiest to insert when the
charger is folded.
Unfold the charger ('click') (Fig. 4).
3
Put the adapter in the wall socket.
4
Put the appliance in the charger (Fig. 5).
5
, The charging light starts to flash green to
indicate that the appliance is charging (Fig. 6).
, When the battery is fully charged, the
charging light lights up green continuously.
All manuals and user guides at all-guides.com
, After approx. 30 minutes the charging light
goes out to save energy.
Optimising the lifetime of the
rechargeable battery
Discharge the rechargeable battery completely
twice a year by letting the motor run until it stops.
Then fully recharge the battery.
Using the appliance
You can use the appliance wet or dry to shave
or trim hair on all parts of the body below the
neckline. Do not use this appliance to shave or trim
facial or scalp hair.
Tip: Take your time when you first start to shave
sensitive areas. You have to acquire practice with the
appliance. Your skin also needs some time to adjust to
the procedure.
Trimming
The trimming comb allows you to cut hair to 5
different lengths.
Start with the highest setting (5) to acquire practice
with this appliance.
Hair length setting
Hair length after trimming
1
3mm
2
5mm
3
7mm
4
9mm
5
11mm
Hold the appliance in the trimming position,
1
with the trimming unit pointing upwards and
the shaving unit pointing downwards (Fig. 7).
Press the hair length setting selector (1)
2
and then move it up or down (2) to select a
setting (Fig. 8).
-
The two lines next to the setting selector show
which setting you have selected (Fig. 9).
Press the trimming unit on/off button once to
3
switch on the trimming unit (Fig. 10).
To trim the hair, move the trimming comb
4
through the hair slowly (Fig. 11).
Tips
-
Always make sure that the tips of the trimming
comb point in the direction in which you move
the appliance.
-
Make sure that the flat part of the trimming
comb is always fully in contact with the skin to
obtain an even result.
-
Since all hair does not grow in the same
direction, you need to move the appliance
in different directions (upward, downward
or across).
-
Trimming is easier when the skin and ha
are dry.
When you are finished, press the trimmin
5
unit on/off button again to switch off the
trimming unit (Fig. 10).
shaving
Before you use the shaving unit, always check
for damage or wear. If the shaving unit is dam
or worn, do not use it, as injury may occur.
Replace a damaged shaving unit before you u
again (see chapter 'Replacement').
Hold the appliance in the shaving position
1
with the shaving unit pointing upwards an
the trimming unit pointing downwards (Fig
Press the shaving unit on/off button once
2
switch on the shaving unit (Fig. 13).
Place the shaving unit on the skin (Fig. 14
3
Move the appliance against the direction
4
hair growth while you press it lightly (Fig
Tips
-
Stretch your skin with your free hand to m
the hairs stand upright.
-
Make sure that the shaving unit is always fu
contact with the skin.
-
If the hairs are longer than 10mm, trim the
first to make shaving easier.
To switch off the shaving unit after use, p
5
the shaving unit on/off button again (Fig. 1
Cleaning and maintenance
Clean the appliance after every use.
Never use compressed air, scouring pads, abr
cleaning agents or aggressive liquids such as p
or acetone to clean the appliance.
Note: The trimming unit and shaving unit do not
any lubrication.
Switch off the appliance.
1
Rinse the appliance under the tap.
2
Cleaning the shaving unit
Pull the shaving unit off the
3
appliance. (Fig. 16)
Note: The shaving unit is very delicate. Handle
carefully. Replace the shaving unit if it is damage
Advertisement
