Specifications - Audio Technica ATW-1235 Installation And Operation Manual

Specifications

OVERALL SYSTEM
Operating Frequency
Frequency Stability
Modulation Mode
Maximum Deviation Range
Operating Range
Operating Temperature Range
Frequency Response
RECEIVER
Receiving System
Image Rejection
Signal-to-noise Ratio
Total Harmonic Distortion
Sensitivity
Intermediate Frequency
Audio Output
Unbalanced:
Balanced:
Output Connectors
Power Supply
Dimensions
Weight
Accessories Included
UNIPAK TRANSMITTER
RF Power Output
Spurious Emissions
Dynamic Range
Input Connections
Battery
Current Consumption
Battery Life
Dimensions
Net Weight (without battery)
HANDHELD TRANSMITTER
RF Power Output
Spurious Emissions
Dynamic Range
Microphone Element
ATW-T36HE
ATW-T37C
Battery
Current Consumption
Battery Life
Dimensions
ATW-T36HE
ATW-T37C
Net Weight (without battery)
ATW-T36HE
ATW-T37C
Accessory Included
† In the interest of standards development, A.T.U.S. offers full details on its test methods
to other industry professionals on request.
6
†
VHF high band, 169.505 to 213.800 MHz
±0.005%, single-frequency
crystal-controlled
FM
±30 kHz, traveling frequencies ±15 kHz
200' minimum
41° F (5° C) to 113° F (45° C)
100 Hz to 15 kHz
Dual independent receivers, automatic
switching diversity reception
≥ 60 dB
112 dB at 30 kHz deviation
(IEC-weighted), maximum modulation
75 kHz
≤ 1% (10 kHz deviation @ 1 kHz)
5.6 µV for 60 dB S/N (IEC-weighted)
10.7 MHz
100 mV (at 1 kHz, ±5 kHz deviation,
10k ohm load)
31.6 mV (at 1 kHz, ±5 kHz deviation,
10k ohm load)
Unbalanced: / " phone jack
1
4
Balanced: XLRM-type
120V AC 60 Hz; or 12-18V DC,
350 mA, with external supply
8.27" (210.0 mm) W x 1.93" (49.0 mm) H
x 8.86" (225.0 mm) D
3.9 lbs (1.8 kgs)
Two whip antennas, rack mount adapters
50 mW Max
Under federal regulations
≥90 dB
High impedance, low impedance, bias
9V (NEDA type 1604) alkaline, not included
35 mA typical
Approximately 10 hours (depending on
battery type and use pattern)
2.40" (61.0 mm) W x 4.23" (107.4 mm) H
x 1.08" (27.5 mm) D
2.8 oz (78 grams)
50 mW Max
Under federal regulations
≥90 dB
A-T Hi-ENERGY ® dynamic hypercardioid
A-T condenser hypercardioid
9V (NEDA type 1604) alkaline, not included
35 mA typical
Approximately 10 hours (depending on
battery type and use pattern)
9.27" (235.5 mm) long,
1.49" (37.9 mm) body dia.
9.38" (238.3 mm) long,
1.46" (37.1 mm) body dia.
8.6 oz (245 grams)
7.2 oz (204 grams)
Stand clamp
Optional System Accessories
MICROPHONES AND CABLES
AT829cW AT829 miniature cardioid condenser microphone only,
terminated for use with UniPak transmitter. Includes
clothing clip and windscreen.
MT830cW MT830R subminiature omnidirectional condenser
microphone only, terminated for use with UniPak
transmitter. Includes clothing clip and windscreen.
MT830cW-TH "Theater" model, same as MT830cW except beige color
mic and cable for concealment.
AT831cW AT831b miniature cardioid condenser microphone only,
terminated for use with UniPak transmitter. Includes
clothing clip and windscreen.
AT851cW AT851a surface-mount wide-range hemi-cardioid
condenser microphone only, terminated for use with
UniPak transmitter.
AT857AMLcW AT857AMLa 19" gooseneck cardioid microphone only,
terminated for use with UniPak transmitter. Mounts to
5 / "-27 thread. Includes windscreen.
8
AT889cW Headworn noise-canceling condenser microphone only,
terminated for use with UniPak transmitter. Includes
windscreen and cable clip.
ATM35cW ATM35 high-intensity miniature cardioid condenser
microphone only, terminated for use with UniPak
transmitter. Includes AT8418 clip-on instrument mount.
ATM73cW ATM73a headworn cardioid condenser microphone only,
terminated for use with UniPak transmitter.
ATM75cW ATM75 headworn cardioid condenser microphone only,
terminated for use with UniPak transmitter. Includes
windscreens and cable clip.
PRO 8HEcW PRO 8HEx headworn hypercardioid dynamic microphone,
terminated for use with UniPak transmitter. Includes
windscreen and cable clip.
PRO 35xcW PRO 35x cardioid condenser microphone only, terminated
for use with the UniPak transmitter. Includes AT8418
clip-on instrument mount.
AT-GCW Hi-Z instrument/guitar cable with
terminated for use with UniPak transmitter.
XLRW Connecting cable for UniPak transmitter with an XLRF-type
input connector, for Lo-Z microphones with XLRM-type
output terminations.
TRANSMITTER ACCESSORIES
ATW-VP10 Vinyl pouch with belt clip to hold UniPak transmitter.
AT8114 Foam windscreen for handheld transmitter.
AT8141 Water-resistant pouch for UniPak transmitter.
AT8431 Stand clamp for handheld transmitter,
AT8456 Stand clamp for handheld transmitter,
INTERCHANGEABLE ELEMENTS (for use with ATW-T37C transmitter)
AT853C-ELE Cardioid element.
AT853H-ELE Hypercardioid element (included).
AT853O-ELE Omnidirectional element.
AT853SC-ELE Subcardioid element.
RECEIVER ACCESSORIES
AT8628 Mounting plate adapter allows rack-mounting two
ATW-R12 receivers side-by-side in a single 19" rack space.
ATW-A10 Pair of VHF ground-plane antennas with
mounting to microphone stands, etc. Takes RF cables with
PL259 connectors, not included.
ATW-D12a Active, unity-gain VHF antenna distribution system
provides two "1-in, 4-out" amplifier/splitters; connects a
pair of antennas to as many as four diversity receivers.
Includes two antennas, two input cable adapters and eight
output cables.
ATW-RA1 Rack-mount antenna kit brings antenna inputs to the front
of receiver for ease of setup, or when receiver is enclosed
in a metal rack. Includes a pair of extendible antennas.
NOTE: Two adapter kits are required when mounting
two receivers side-by-side in a single 19" rack space.
1 / " phone plug,
4
5 / "-27 threads.
8
5 / "-27 threads.
8
5 / "-27 thread for
8