BMW K 1200 GT Rider's Manual page 47

Resetting average
consumption
Repeatedly press BC but-
ton 1 until the average fuel
consumption appears in the
display.
Hold the BC button down
for at least 2 seconds (RE-
SET).
The display shows
"--.- l/100 km".
Oil level
The "Oil" reading gives you
an indication of the engine
oil level. You can call up this
reading only when the motor-
cycle is at a standstill.
The preconditions for auto-
matic registration of the oil
level are as follows:
Engine idling for at least 30
seconds.
Engine at operating temper-
ature.
Make sure the motorcycle is
upright.
The readings mean:
Oil level is correct
Check the oil level with
the dipstick the next
time you stop for fuel. If you
call up another reading on the
on-board computer, this sym-
bol remains visible beside the
line.
BC
Oil level cannot be
measured (conditions as
stated above not satisfied).
The most recently measured
level is displayed for 5
seconds when you next
switch on the ignition.
The oil sensor might be
defective if the "Check
oil level" message reappears
even though a check with the
dipstick reveals that the oil
level is correct. In this case,
4
45
z