Special Note - Cerwin-Vega pro mobile Series Owner's Manual

Features/Specifications
Once the Back Cover/Diaphragm assembly is unscrewed and removed..NOW get the NEW
Back Cover/Diaphragm assembly and reverse the process. Place the 4- PHILIP head Machine
screws back into place. Using a DVM (or AA battery) make sure that the tweeter is actualy
connected. "Pop" it a couple times or read the impedance (its 8 W) Once tested then finish putting
the Back Cover/Diaphragm assembly tightly. BUT not too tightly!
With the Back Cover/Diaphragm assembly back on
re attach the passive tweeter crossover as shown
to the right. NOTE: the tweeter is actuallly
connnected "Out-Of-Phase". This is VERY
IMPORTANT for proper sound quality. Use
your Smartphone and the Polarity Tester App
you put on it to double check this.

SPECIAL NOTE:

Included with the speaker set are
2- 4 W resistors. These are there
just in case you think that the horns
are TOO bright. Put 1 in line with
each of the the crossovers INPUT.
That will attenuate the tweeter
about 3dB. If that sounds good to
you, ....leave it there.
Philips Screw
CVBCD
( Tweeter Diaphrapm
Replacement Assembly)
OUT OF PHASE!!
Driver
9