Configuring Opc Ua Clients (Uaexpert) - Siemens SIMATIC RTU3041C Manual

2 Engineering
2.2.3

Configuring OPC UA Clients (UaExpert)

This section explains how to monitor the data points of the TCSB via OPC UA.
The following is required to use the OPC UA Client "UaExpert":
–
"UaExpert" is installed on your PC.
–
OPC UA Server (TCSB) is activated (see
–
The configuration of the RTU3041C is loaded into the RTU.
To read the data via the OPC UA Client "UaExpert", proceed as follows:
1. Assign the PG/PC Client an IP address in the subnet of the router (according
to Table
2. Start "UaExpert" and click the "Add Server" button.
3. In the dialog, double-click "< Double click to Add Server... >" in the "Custom
Discovery" list area.
Monitoring of Remote Measurement Points
Entry ID: 109739240, V3.0,
2-1).
06/2021
Section 2.2.2).
51