Kia Cerato 2019 Owner's Manual page 502

Maintenance
Front windscreen wiper blade
For your convenience, move the
windscreen wiper blades to the serv-
ice position as follows;
After turning off the engine, move the
wiper switch to the single wiping
(MIST) position within 20 seconds
and hold the switch more than 2 sec-
onds until the wiper blade is in the
fully up position.
CAUTION
Do not allow the wiper arm to fall
against the windscreen, since it
may chip or crack the wind-
screen.
8 60
OBD078015
Type A
1. Raise the wiper arm.
2. Lift up the wiper blade clip (1).
Then pull down the blade assem-
bly (2) and remove it.
3. Install the new blade assembly.
4. Return the wiper arm on the wind-
screen.
5. Turn ignition to the ON position
and wiper arms will return to the
normal operating position.
OYB046462R
OYB046463R