Load The Software Applications For Your Cd-Rw; Connect The Power Cords - HP x4000 Getting Started Manual

Setting Up And Using Your Workstation
Setting Up Your Workstation

Load the Software Applications for Your CD-RW

The CD-RW software for the CD-RW drive that is installed in your HP
x4000 Workstation is not included in the pre-loaded software. You must
install the applications manually from the Applications CD-ROM
(provided with the workstation or as an accessory kit) before you can use
the write/re-write functionality of the drive.
If you do not install these software packages, you can only use the
CD-RW drive's read functionality.

Connect the Power Cords

WARNING For your safety, always connect equipment to a grounded wall
outlet. Always use a power cord with a properly grounded plug,
such as the one provided with the equipment, or one in
compliance with your national safety standards. You disconnect
the workstation from the power by removing the power cord
from the power outlet. This means the equipment must be
located close to an easily accessible power outlet.
14
This manual downloaded from http://www.manualowl.com
1. Connect the power cords to the rear of the monitor and the
workstation.
2. Connect the both power cords to a grounded outlet.
Chapter 1