Table of Contents
Advertisement
2.10 Replacing the cover
After you have installed all the internal components and you have
connected all the necessary cables, you are now ready to put the system
back together.
Follow these steps to re-assemble
the system.
1.
With the chassis lying on its
side, hook the swivel edge of
the drive frame to the main
chassis.
2.
Sway the drive frame inward
until it fits completely. The
side tabs on both ends of the
drive frame should snap
perfectly to the chassis edge.
3.
Re-attach the power socket
module and secure it with the
screw you removed earlier.
4.
Turn the chassis upright.
5.
Place the cover over the
chassis leaving about two
inches from the rear panel.
A S U S T e r m i n a t o r 1 C 3 b a r e b o n e s y s t e m
A S U S T e r m i n a t o r 1 C 3 b a r e b o n e s y s t e m
A S U S T e r m i n a t o r 1 C 3 b a r e b o n e s y s t e m
A S U S T e r m i n a t o r 1 C 3 b a r e b o n e s y s t e m
A S U S T e r m i n a t o r 1 C 3 b a r e b o n e s y s t e m
S i d e t a b
S i d e t a b
S i d e t a b
S i d e t a b
S i d e t a b
2 - 1 7
2 - 1 7
2 - 1 7
2 - 1 7
2 - 1 7
Advertisement
Table of Contents
