Table of Contents
Advertisement
Model SB1063
20. Press Manual Oil button (see Figure 30,
Item B). The light should illuminate, oil
pump heard, and oil distribution indicated at
ways. Do not hold button for longer than four
minutes or oil pump can overheat.
21. Turn work lamp ON at back of lamp shroud
(see Figure 7, View R), and then press
LIGHT button shown in (see Figure 15).
• Light should illuminate.
22. Press POWER (O) button to shut machine
OFF shown in Figure 14 on control panel.
• Red power light will illuminate.
• Control panel screen will turn off.
• Green POWER (I) button light (see
Figure 14) will go out indicating that
POWER OFF (O) button is functional and
machine is powered but not ready for
commands.
23. "Congratulations! The Test Run is complete.
Proceed to your desired machine operations
outlined in the Fagor CNC Manual(s).
-26-
P R E P A R A T I O N
Inspections &
Adjustments
The following list of adjustments were performed
at the factory before the machine was shipped:
Gib Adjustment ........................................Page 44
Be aware that machine components can shift
during the shipping process. Pay careful
attention to the adjustments above during
operation of the machine. If you find that
the adjustments are not set according to the
procedures in this manual or your personal
preferences, re-adjust them.
Spindle Break-In
The high-quality bearings and gears used in the
mill are manufactured to very close tolerances.
The spindle bearings and associated drive
system have been broken-in at the factory and no
pre-load break-in is required.
Since the mill head was rotated parallel to
the table for shipping purposes, you will need
to tram the spindle with the table if your first
operation requires 90° alignment.
For Machines Mfd. Since 5/19
Advertisement
Table of Contents
