Location - Southbend SB1063 Owner's Manual

Model SB1063

Location

Physical Environment
Physical Environment
Location is important for safe operation and
Location is important for safe operation and
longevity of machineandparts. For best
longevity of machine and parts. For best results,
results, operate this machine in a an
operate this machine in an environment that
environment that is free fromvibration,
is free from vibration, excessive moisture,
excessive moisture, hazardous or flammable
hazardous or flammable chemicals, airborne
chemicals, airborne abrasives, or extreme
abrasives, and extreme conditions. The
conditions. The ambient workingtemperature
ambient working temperature requirement
requirement is: 41°F to 104°F (+5°Cto +40°C);
is: 41°F to 104°F (+5°C to +40°C) and the
and the storage temperature is -13°Fto 158°F
storage temperature is -13°F to 158°F (-25°C
(-25°C to +70°C). T he relative humidity for both
to +70°C). The relative humidity for both is
is below 90% (non-condensing). M akesurethat
below 90% (non-condensing). Make sure that all
all environmental conditions listed in the Fagor
environmental conditions listed in the Fagor
Operating Manual CNC 8055M are met. For the
Operating Manual are met. For the list; refer
list; refer to Precautions Against Product
to Precautions Against Product Damage.
Damage, starting on Page 13.
Electrical Installation
Electrical Installation
Place this machine near an existing power
Place this machine near an existing power
source. Make sure all power cords are protected
source. Make sure all power cords are protected
from traffic, material handling, moisture,
from traffic, material handling, moisture,
chemicals, or other hazards. Make sure to leave
chemicals, or other hazards. Make sure to leave
access to a means of disconnecting the power
access to a means of disconnecting the power
source or engaging a lockout/tagout device.
source or engaging a lockout/tagout device.
Lighting
Lighting
Machine lighting is adequate for safe operation.
Machine lighting i s adequate for safe operation.
Keep in mind that actual
mounting footprint for
machine is larger than
the machine base because
of the overhanging electrical
box feet.
4 Hard Point
Base Mounting Loc.
2 Electrical Box
Support Feet
-20-
P R E P A R A T I O N
Weight Load
Refer to the Machine Specifications for the
weight of your machine. Make sure that the
surface upon which the machine is placed will
bear the weight of the machine, additional
equipment that may be installed on the machine,
and the heaviest workpiece that will be used.
Additionally, consider the weight of the operator
and any dynamic loading that may occur when
operating the machine.
Space Allocation
Consider the largest size of workpiece that will
be processed through this machine and provide
enough space around the machine for adequate
operator material handling or the installation
of auxiliary equipment. With permanent
installations, leave enough space around
the machine to open or remove doors/covers
as required by the maintenance and service
described in this manual.
Wall
Min.
62"
72"
24"
+
Min.
30"
Figure 9. Clearances.
For Machines Mfd. Since 5/19
Children or untrained
people may be seriously
injured by this machine.
Only install in an access
restricted location.
= Power connection
= Air connection
Minimum ceiling height
with 3" clearance for
spindle motor cooling
airflow is 8 feet.
63"
46"
49"