Connecting
4.5 PN Basic connection module
4.5
PN Basic connection module
4.5.1
Description
The connection module Basic PN was specially developed for installation in the control cabinet.
The terminating connector protrudes through the panel of the control cabinet so that the HT 10
can be connected from the outside.
Figure 4-8
The connection module Basic PN is not hot plug-capable.
The HT 10 can be connected either directly to the NCU or to the PCU as a Thin Client.
4.5.2
interfaces
The connector for the HT 10 is located on the front of the Basic PN connection module.
The other interfaces of the connection module are located at the rear:
54
System configuration (example)
Handheld Terminal HT 10
Equipment Manual, 09/2020, A5E47430965B AA