Re-Programming; Indicating Lamps - Asko 1755 How To Use Manual

Re-programmings
Protected start programme
You can also prevent children starting the machine by playing with the
pushbuttons by programming the machine so that it will start only if the Start
push-button is pressed and held for three seconds.
1. Press 5 times, which gets you into the
protected start programme.
2. Press and you get protected start (3 sec)
or
Press to revert to normal operation.
Too little water in the machine?
The water level is correct when it reaches up to the marking of the lower
spray pipe bearing, see picture.
If there is insufficient water in the machine, it may be because the supply pressure
is too low. This can be compensated for by altering the admission time.
1. Press five times within 15 seconds to get into the water level modification
programme.
2. Press to get the normal inlet time
to get 25 % increase
to get 50 % increase
to get 100 % increase
to get 150 % increase
How to set the pumping out time
If you have a longer outlet hose or if there by other reason is a too short time for the
machine to pump out the water, the pumping-out time can be changed. Do like this:
1. Press 5 times within 15 seconds. Then you get into the changing programme.
2. Press to get an outlet time of
Press "
Press "
Press "
Press "
The indicating lamps . . .
The indicating lamps serve several purposes: besides showing the selected programme ,
they are also used if you need to trace a fault in the machine.
. . . display programme contents
T indicating lamps show what a selected programme contains.
For Normal wash, for example, the following lamps would be lit:
8
20 seconds
" 25 "
" 35 "
" 45 "
" 85 "
Normal time
The indicating lamps show: