Wheel (Rim) Replacement; Tires - Dinli DL702 Service Manual

WHEELS/TIRES

Wheel (Rim) Replacement

● Remove the wheel (see Wheel Removal)
● Disassemble the tire from the rim (see Tire Removal).
○ Remove the air valve and discard it.
Replace the air valve whenever the tire is replaced. Do not
reuse the air valve.
● Install a new air valve in the new rim.
○ Remove the valve cap, lubricate the stem with a soap and water
solution, and pull the stem [A] through the rim from the inside
out until it snaps into place.
Do not use engine oil or petroleum distillates to lubricate the
stem because they will deteriorate the rubber.
● Mount the tire on the new rim (see Tire Installation).
● Install the wheel (see Wheel Installation).

TIRES

Tire Removal
● Remove the wheel.
● Unscrew the valve core to deflate the tire.
○ Use a paper valve core tool.
● Lubricate the tire beads and rim flanges on both sides of the
wheel with a soap and water solution, or water. This helps the
tire beads slip off the rim flanges.
Do not lubricate the tire beads and rim flanges with engine
oil or petroleum distillates because they will deteriorate the
tire.
● Remove the tire from the rim using a suitable commercially
available tire changer.
○ The tires cannot be removed with hand tools because they fit
the rims tightly.
CAUTION:
CAUTION:
CAUTION:
NOTE
【2-6】
A
A