Table of Contents
Advertisement
MN000397A01-B
Chapter 1: Performing Upgrades
Figure 1: PDA and PC – Connected
For Windows XP, the ActiveSync application starts.
For Windows Vista, Windows 7, Windows 8, or Windows 10, the Windows Mobile Device Center
starts.
If ActiveSync or Windows Mobile Device Center does not start, ensure that the PDA is set to the
USB OTG mode. See
Windows Mobile Device Center still does not start, launch the application manually from your
PC.
For Windows 10, if the Device is not connected message appears, set up the PDA for
connection with a Windows 10 PC. See
PC on page
44.
4 Insert the CD provided by Motorola Solutions and run the Setup.exe file to start the KVL
Software Installation Wizard.
The End User License Agreement screen appears.
5 Click Accept and follow instructions on the consecutive screens.
During the installation, the PDA may restart several times. If the PDA is password protected, you
need to enter the password and tap Unlock after each restart.
IMPORTANT: If a prompt to disconnect and reconnect the USB Programming Cable
appears, disconnect and reconnect the USB Programming Cable, and click OK. If the
PDA is password protected, enter the password and tap Unlock.
6 When the installation is completed, exit the KVL Software Installation Wizard.
7 Disconnect the USB Programming Cable from the PDA.
8 Connect the Security Adapter to the PDA.
If the Security Adapter is not detected automatically, ensure that the PDA is set to the USB OTG
mode. See
Setting the PDA to the USB OTG Mode on page
9 If you wanted to upgrade/reinstall the KVL application, the procedure is complete. To upgrade
the Security Adapter software, go to
36
Setting the PDA to the USB OTG Mode on page
Setting Up the PDA for Connection with a Windows 10
Upgrading the Security Adapter on page
43. If ActiveSync or
43.
37.
Send Feedback
Advertisement
Table of Contents
