Dhcp; Navigating To A Device - Western Digital OpenFlex F3x00 Manual

Installation Guide
1.3.2 DHCP
When the E3000 BMC module is powered on, it will try to establish an IP address using DHCP. The E3000
and F3x00 require access to a DHCP Server to access the OCGUI. Access to a DHCP server should be
setup ahead of time to ensure the installation of the product is not gated. If a DHCP server is not present
on the network that the E3000 is connected to, access to the BMC and the OCGUI will not be available.
1.3.3 Navigating to a Device
This task provides instructions for using the OCGUI to navigate to a device's dashboard through any other
fabric-connected device.
Before you begin: The BMC's MAC address is listed on a label affixed to the module's side. This MAC
address can be used to determine the IP addresses assigned via DHCP to the OpenFlex E3000 chassis and
the F3x00 storage devices contained within it.
Figure 6: BMC Module MAC Address Label
Step 1 : Open a browser and enter the IP address for any fabric-connected device into the address bar.
The login page for the device appears:
Step 2 : Enter a valid username and password, and click the Login button:
1. Installation
1.3 Before You Begin
7