Hearth and Home Technologies MEZZO Installation Instructions

MEDIA-AMBER-36/48/60/72, MEDIA-CLEAR-36/48/60/72, MEDIA-COBALT-36/48/60/72,
MEDIA-EBONY-36/48/60/72, MEDIA-FOG-36/48/60/72, MEDIA-RED-36/48/60/72
MODELS: MEZZO, MEZZO-B, MEZZO-C, CRAVE, CRAVE-B, CRAVE-C, PRIMO
Leave this manual with party responsible for use
and operation.
WARNING! Choking Hazard! Keep media out of reach
of children.
CAUTION! Risk of Burns! The fireplace should be turned
off and cooled before media is installed.
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
NOTE: MEDIA-FOG-60 is not approved for use with
PRIMO60/PRIMO60ST Propane appliances. Sooting could
occur.
Cleaning the Media
During shipment of the media, dust and debris can ac-
cumulate. It is recommended that the media be rinsed
thoroughly with water to remove dust and small particles.
An easy method to clean the media is to place the media
into a pail and rinse thoroughly. Spread the media out over
paper towels and allow the media to dry before installing
them into the fireplace.
INSTALLATION
Note: If both the media and logs will be installed, the logs
must be installed first.
1. Choose 7 - 10 round pieces of media approximately
1/2 inch in size and set them aside. These will be used
later to conceal the pilot end of the burner. Reference
Figure 1 for choosing round pieces of glass.
WARNING! Risk of Explosion! DO NOT put any flat
media pieces larger than 1/2 inch in diameter near pilot.
Delayed ignition could occur. Use only round 1/2 inch
pieces near pilot.
NO
Figure 1. Selecting Flat Media for Pilot Cover.
Hearth & Home Technologies • MEZZO/CRAVE/PRIMO Media Installation Instructions • 2300-945 Rev. N • 7/19
- Installation Instructions -
YES
2. The included media placement jig, shown in Figure 2
(MEZZO/CRAVE) and Figure 3 (PRIMO), MUST be
used any time media are placed on the burner to ensure
that none end up in the burner lighting area. Verify that
the media placement jig is correctly installed in place in
the appliance. See Figure 4.
WARNING
Delayed Ignition Risk
• Place media according to instructions.
• Do NOT place media in area in front of pilot
• Do NOT place media in a position that they may
fall into area in front of pilot.
• Do NOT use any media other than the media
supplied with this fireplace.
• Do NOT exceed one layer of media on base pan.
Fireplace will not function properly.
Delayed ignition may occur.
MEDIA PLACEMENT JIG
PILOT SHIELD
MEDIA TRAY
BURNER
(4836/6048 MODELS)
BURNER
(7260/8472 MODELS)
Figure 2. Media Tray Components -
MEZZO/CRAVE
1