Table of Contents
Advertisement
Table 1. Z9432F-ON switch LED behavior (continued)
LED
LOCATOR LED/System Beacon
Table 2. System management Ethernet port LED
LED
Link LED
Activity LED
Table 3. Z9432F-ON QSFP56-DD port LED
LED
Link/Activity LED
Table 4. SFP+ port LED
LED
Link LED
Activity LED
Prerequisites
The following is a list of components that are required for successful switch installation:
NOTE:
For detailed installation instructions, see
● Z9432F-ON switch or multiple switches, if stacking
● AC or DC country- and regional-specific cables to connect the AC or DC power source to each of the switch AC or DC
power supplies
● Rail mounting brackets for rack installation, included
● Screws for rack installation, not included
● #1 and #2 Phillips screw drivers, not included
● Torx screwdriver, not included
● Ground cable screws for L-bracket, included
● Copper/fiber cables
Other optional components are:
● Ground cable and lug for the frame-end of the ground cable
● Extra mounting brackets
● Extra power supply unit
● Extra fan module
10
The Z9432F-ON switch
Description
● Off—Locator function disabled
● Flashing blue—Locator function enabled
Description
● Off—No module present
● Solid green—Port link is up
● Solid yellow—Module needs attention using the CLI.
● Flashing yellow, one second on; one second off—Port
beacon
● Off—No activity
● Flashing green—Port activity
Description
● Off—No link/activity
● Solid green—Port link is up
● Flashing green ~30ms—Port activity operating
● Solid yellow—Use CLI to check LED status
Description
● Off—No link
● Solid green—Link operating at maximum speed, 10G
● Flashing green—Port activity at maximum speed
● Solid yellow—Link operating at a lower speed,1G
● Off—No link
● Flashing green—port activity
Site preparations
and
Z9432F-ON switch
installation.
Advertisement
Table of Contents
