Dell EMC PowerEdge XE8545 Installation And Service Manual page 89

Figure 94. Removing the system battery
2. To install a new system battery:
a. Hold the battery with the positive side facing up and slide it under the securing tabs.
b. Press the battery into the connector until it snaps into place.
Figure 95. Installing the system battery
Next steps
1. Install the expansion card
2. If applicable, connect the cables to one or more expansion cards.
3. Follow the procedure listed in
4. Confirm that the battery is operating properly, by performing the following steps:
a. Enter the System Setup, while booting, by pressing F2.
risers.
After working inside your system on page 24.
Installing and removing system components 89