Advertisement
sprtool.com
SAFETY PRECAUTIONS
The customer shall ensure that only people thoroughly trained in safe work procedures operate this
machine. Safe working procedures are required when operating rotating machine tools. The misuse of this
machine could result in severe injury or death.
Proper training and safety precautions can help avoid accidents.
Please observe all company and Government work safety practices.
• Keep others clear from the machine when it is running.
• Keep clear of the cutting head and other moving parts. Never try to remove chips while the machine is
running.
• Disconnect the power when inserting or adjusting the cutting tool.
• Wear protective goggles, footwear and ear plugs. Please observe all Company and Government work-
safe practices
• Do not wear loose fitting clothing that could get caught up or wrapped in the machine.
• Flying chips can cut or burn you. Do not remove cuttings with bare hands.
• Do not operate in water. Watch for electrical hazards.
MACHINE SAFETY
• Do Not leave machine unattended while in operation.
• Do not replace brass shear pin (1/8" brazing rod) with steel.
• Beware of pinch points. Keep all body parts clear of the machine while it is running.
Rotating machine parts can cause serious injuries, even death!
Running the X-Axis feed into End-Stops may damage machine.
For maximum safety and performance, read the entire instruction manual before operating this machine.
PAGE 4 OF 16
SPR-MAN-LM
Advertisement
