Operating Instructions; Main Power Button; Operating Touch Display Panel - Napoleon Allure Series Installation And Operation Manual

operating instructions

4.0 operating instructions
EN
WARNING
!
• While the appliance is operating, do not remove the glass panel. This will cause the remote control and touch
panel to disfunction.
Once the appliance has been plugged into a grounded electrical outlet, it is ready to operate.
note:
Ensure the house circuit breakers for the power supply are turned on. In the event of a power failure, the
appliance will lose its memory function and will reset to factory mode when the power returns.
4.1

main power button

The main power button is located on the front bottom right side of the appliance.
4.2

operating touch display panel

WARNING
!
• Do not move or remove the glass panel when the appliance is plugged in and operating. This will cause the
remote control and touch panel to stop functioning.
The touch display panel is shown by LED's on the front bottom right of the appliance. The LED's will
disappear after 10 seconds of no function change. The main power button will be dim.
POWER
FLAME - ORANGE
FLAME - BLUE
HEATER
TIMER
TEMPERATURE
18
W415-1699 / E / 06.01.20
Turns the appliance ON/OFF.
Controls Orange Flame brightness.
6 Settings: F5-F4-F3-F2-F1-F0. Flame dims from F5 to F1.
F5 is the brightest setting and F0 is off.
Controls Blue Flame brightness.
6 Settings: F5-F4-F3-F2-F1-F0. Flame dims from F5 to F1.
F5 is the brightest setting and F0 is off..
Turns the heater ON/OFF.
(H0) - No heater or blower.
(BL) - Blower only.
(H1) - Heater blows warm air (950W).
(H2) - Heater blows hot air (2000W).
NOTE: Heater functions cycle from H0-BL-H1-H2. Press
and hold the heater button for 5s to lock the heater and
temperature setting onto the selected setting. Hold the button
for another 5s to unlock the heater and temperature setting.
Turns the timer ON/OFF.
9 Settings: 0.5h, 1h, 2h, 3h, 4h, 5h, 6h, 7h, 8h. Press button
until desired setting is reached.
1. Press once to turn the touch panel indicator ON.
2. Press button until desired setting is reached.Digital display
shows setting circles as follows:
Display Value
0 1 2 3 4 5 6 7 8 9 N
C
° 18 19 20 21 22 23 24 25 26 27 ON
Temperature
64 66 68 70 72 74 76 78 80 82 ON
F
°
NOTE: Holding the button for 5s will switch the temperature
from C° to F° and vice versa.