Fiat Doblo Owner's Handbook Manual page 87

During the daytime, and with the
dipped headlamps on, the
instrument panel, buttons and
sound system and automatic
climate control displays are set to
maximum brightness.
Proceed as follows to adjust the
brightness:
– press the MENU button
briefly to make the display flash the
previously stored level;
– press button and to set the
required brightness level;
– press the MENU button
briefly to return to the menu screen
or hold the button down to return
to the standard screen without
storing.
Speed warning
(Speed limit)
This function enables setting of the
vehicle speed limit (km/h or mph).
When this limit is exceeded the
driver is immediately alerted (see
section "Warning lights and
messages").
To set the desired speed limit,
proceed as follows:
– briefly press the MENU
button: the display will show the
words (Speed Beep);
– press the or button to select
speed limit activation (On) or
deactivation (Off);
– if the function is on, press the
buttons to select the required
speed limit and then press MENU
to confirm;
NOTE The speed may be set
anywhere between 30 and 200
km/h or 20 and 125 mph,
depending on the previously chosen
unit (see "Setting the unit of
measurement (Unit)"). The setting
will increase/decrease by 5 units
each time button / is pressed.
Hold down the / button to
automatically increase/decrease the
setting rapidly. Complete the
adjustment with single presses of
the button when you approach the
desired value.
– press the MENU button
briefly to return to the menu screen
or hold the button down to return
to the standard screen without
storing.
To cancel the setting, proceed as
follows:
– briefly press button MENU
(On) will flash on the display;
– press button , (Off) will flash on
the display;
or
– press button MENU
return to the menu screen or hold
the button down to return to the
standard screen without storing.
Trip B data (Activating
Trip B)
This function can be used to
activate (On) or deactivate (Off) the
Trip B display (partial trip).
For more information see the "Trip
computer" section.
Proceed as follows to switch the
function on/off:
– press the MENU
briefly to make the display flash On
or Off according to the previous
setting;
– press the or button to select;
,
briefly to
button
83