Fiat Doblo Owner's Handbook Manual page 182

❒ use the wrench provided to fully
tighten the bolts, passing alternately
from one bolt to the opposite one,
as per the numerical sequence
illustrated in fig. 191.
191
At the end of the
operation
❒ fix bracket A fig. 192 to the wheel
after passing it through the hole,
insert the threaded pin into one of the
bolt holes and secure by tightening
knob B;
❒ for vehicles with alloy rims take the
adapter D fig. 193 and fit the plastic
spacer C between the spring and the
flange of the bracket. The plastic fin
must be directed downwards and
perfectly coincide with the flange cut
part;
178
192
F0V0158
193
❒ fit the bracket E fig. 194 in the
adapter D, fit the pin in the hole and
fasten by the knob F;
❒ position the wheel vertically and rest
the fitted adaptor on the inside of the
rim, then using the screws provided
fix the wheel to the adaptor, using the
socket wrench for the wheel nuts G
fig. 195. Tighten the screws with
the wheel removal wrench.
194
F0V0194
195
F0V0214
NOTE Use the spare wheel covering
bag to protect the replaced alloy
wheel.
❒ Check that the position of the
replaced wheel under the platform is
correct (the lifting system is equipped
with a clutch to limit the end of the
stroke, incorrect positioning may
jeopardise safety;)
❒ put the jack and the tools back in the
dedicated tool bag;
F0V0215
F0V0216