Fiat 500X Owner's Handbook Manual page 26

DAYTIME RUNNING
LIGHTS (DRL)
"Daytime Running Lights"
18) 19)
With the ignition device turned to MAR
and the light switch ring nut turned to
position O the daytime running lights
are automatically activated (the other
lights and interior lighting remain off).
FOG LIGHTS
(where provided)
Press the button to turn on the fog
lights with side lights and dipped beam
headlights on.
When the fog lights are on, the side
lights and number plate lights are also
on, while the daytime running lights
are off.
Press the button again or turn the
switch ring nut to O in order to switch it
off.
REAR FOG LIGHT
(where provided)
The button that controls switching on
and off of the rear fog light is integrated
into the light switch.
Press the button to turn on the rear
fog light with side lights and fog lights
on.
24
PARKING LIGHTS
These lights can be switched on with
ignition device at STOP or with key
removed, by moving the light switch
ring nut to position O and then to
position , the switch will go back
to position O.
The warning light switches on in
the instrument panel.
HEADLIGHTS OFF TIMER
(Follow me home)
Activation
With headlights on, bring the ignition
device to STOP.
Within 2 minutes, rotate the light switch
nut to O: the timing set previously
through the Menu (0, 30, 60, up to 90
seconds) starts.
Deactivation
This function is deactivated by
switching on the headlights, the side
lights or bringing the ignition device to
MAR.
"Follow me home" function
interaction with system
TM
Uconnect system
If on the menu Uconnect™ the timer is
set to 0 seconds it is possible, using
the high beam lever, to turn on the
lights for a pre-set time of 30 seconds.
It is possible to activate the lights 7
times up to a maximum of 210
seconds.
If, however, a timing (of 30 or 60
seconds, for example) has been set
through the "Settings" menu of
Uconnect™, each time the engine is
switched off, the "Follow me home"
function will be activated for the
duration of that timing (you will not be
able to change it using the light switch),
only if the ring nut A fig. 29 is rotated
to position O.
MAIN BEAM HEADLIGHTS
With the light switch ring nut turned to
position or AUTO push the left stalk
A fig. 30 forwards, towards the
dashboard.
With main beam headlights on, the
warning light on the instrument
panel will come on at the same time.